Page 17 - Digimed_HS_HCS_screws_DE+EN-2021

APPLICATION GUIDE
2.5 MM HS HEADED SCREW

APPLICATION GUIDE
3.0 MM HS HEADED SCREW AND 3.0 MM HCS COMPRESSION SCREW
WHEN USING THE SYSTEM ALWAYS PAY ATTENTION TO THE CORRECT COLOR ASSIGNMENT OF THE
INSTRUMENTS AND SCREWS!

3.0 MM HS HEADED SCREW 3.0 MM HCS COMPRESSION SCREW
Color code: Yellow green Color code: Yellow green

Kirschner w. trocar point, rd. end, Ø 0.9
mm, L. 80 mm
Ref. No. 91-004-0330-011-080
Drill the Kirschner wire to the desired depth into the bone using an image converter to check the placement.

HBS-Measuring Sleeve for Guide Wire
Ref. No. 91-INS-8203-00

Slide the measuring sleeve over the round end of the Kirschner wire, making sure that the tip of the
instrument rests against the bone. The length of the screw can be determined by means of the scaling on
the measuring sleeve. Check the length at the height of the end of the round Kirschner wire.
HBS-AO cann. drill bit Ø 2.1/1.2 mm, 80 mm
Color code: Yellow green
Ref. No. 91-INS-8201-11

Using an image converter to check placement, drill the cannulated drill into the bone above the Kirschner
wire. We recommend inserting the drill into the bone just short of the tip of the Kirschner wire. If you over-
drill the tip of the Kirschner wire, it may lose its hold and be removed when the drill is pulled out!
Countersink, AO, cann., Ø 5.0/1.2 mm, 60 mm
Color code: Yellow green/luminous yellow
Ref. No. 91-INS-8192-50

3.0 HS headed screw
Optionally it is possible to countersink the screw head in the cortex. Place the cannulated countersink over the
Kirschner wire and onto the cortex and slowly rotate the countersink into the cortex. Important: For osteoporotic bone
conditions, it is recommended to perform this step without a power tool. To do this, clamp the countersink into the
screwdriver handle.
Kanul. HBS-Bohrer, extra kurz, Ø 3.0/2.1 mm,
L. 47 mm, Farbcode: Gelbgrün
Ref. No. 91-INS-8200-21

3.0 mm HCS compression screw
Optionally it is possible to deepen the cortex to facilitate screwing in of the head thread of the HCS screws. Guide the
cannulated extra short HBS drill over the Kirschner wire and slowly rotate the countersink into the cortex.

HBS cann .screw driver shaft, HEX 2.0 mm/1.2
mm, 97 mm, AO-conn., Color code: Yellow green
Ref. No. 91-INS-8304-01-SW2.0

Connect the corresponding screwdriver shaft with the screwdriver handle. Place the screw on the screwdriver shaft.
Insert the screw together with the screwdriver over the Kirschner wire and turn the screw clockwise into the bone. Make
sure the screw comes to rest correctly and firmly on the cortex. Check the correct position of the screw with the help of
the image converter and then remove the Kirschner wire.

Digimed Medizintechnik • Kreutzerstrasse 1 • 78573 Wurmlingen • Germany • www.digi-med.de 17